How to maintain your fiber laser cutting machine
How to maintain your fiber laser cutting machine
- Several ways to maintain your laser machine:
4.1 Clean the surface of the equipment to attach dust and cut slag
4.2 Check the joints of the capacitor signal module (at the cutting head).And confirm that the fastening is intact and there is no looseness.
4.3 Clean up the water in the A/C storage tank.
4.4 Equipment homing (including X, Y and Z axes).
4.5 Cleaning waste scraps and debris in waste trailers.
4.6 Check the lubricating oil level in the lubricating oil pump. And If it is not enough, fill it in time.
4.7 Clean the dust on the A/C dust cover net and the water cooler dust cover net.
4.8 Firstly,Check the lubrication condition of each shaft slide rail, rack, gear and z-axis screw.
Secondly,And manually add lubricating oil on the upper end surface and the two end surfaces of the guide rail.
Thirdly,And the main mechanical linkage end face of the rack, gear and lead screw is evenly distributed.
Finally,Apply lithium grease. (If there is rust, be sure to remove the rust first.)
4.9 Check the cooling water level of the water cooler, if not enough to raise it in time.
4.10 Firstly,Check the water pipes of the cooling water pipe to confirm that there is no extrusion, bending, grinding, scratching and water leakage.
Secondly,check the water pipe joints (push-in connectors and ordinary threaded joints) to confirm that the connection is normal and there is no water leakage.
4.11 Check if the cooling water pressure gauge value is normal.
4.12 Clean the water tank of the water cooler.
4.13 Replace the water cooler to circulate cooling water.
4.14 Most importantly,Replace the water cooler filter.
4.15 Clean the water filter of the water cooler.
4.16 Check whether the crimping of each terminal of the terminal block in the electrical cabinet is firm.
And whether the electrical plug connectors are firmly connected, confirm that there is no looseness.
4.17 Moreover,Clean up dust in the electrical cabinet.
4.18 Check the top wire of the reducer under each axis motor to confirm that it is not loose.
4.19 For instance,Check the center of the beam to make sure it is concentric with the nozzle hole.
4.20 Finally,Check the protective lens to make sure it is clean and free of dirt.
XT laser is a lead laser machine manufacturer in China.
Pls feel free to contact us for more informations.
Serena
Jinan Xintian Technology Co., Ltd.
Tel/Whatsapp:+8615806603572
Skype:xtlaser0302
Email:xintian115@xtlaser.com
